A little taster of some planned new lines – relic hardware. Starting with Fender spec control plates and neckplates in both chrome and nickel. No chemicals used on these – I am going for a gently aged look rather than out and out relic. That could of course change depending on customer feedback.
The screws will also be lightly aged and may show a little rust – I will be doing tests this week to get the look where I want it. I will also be doing tests on the rest of the hardware: knobs, jack cups, end pins etc. Not tuners though as I have a little surprise on that front in about a month.
It is extremely difficult getting photos that really show the detail but the close-up shots below are pretty representative. No swirls or obvious sandpaper/abrasive marks and very little (if any) rub through of the plating.
I am aiming to get all the tests finished this week and the first products on the site at the beginning of next week.
Feedback welcome!
Hi Gavin, good news about the relic hardware !! i am abig fan of all that is relic,d. eagerly awaiting the arrival. keep up the good work. Allan.
Hi Allan,
I’m running a bit behind but should hopefully have the neck and control plates on the site by the weekend (just have to get the screws ready). Then knobs and jackplates to follow!
Gavin